Repair Rework Welder

Description

Staff Management is looking for a Repair Rework Welder in the Humboldt, TN area. This position performs a rework and salvage operation on the various axle housings, weldments, and components. Requires the use of gas metal arc welding (GMAW) and air arc equipment, a Hydro-Tel Mill, Sidney lathe, radial drill, expander, core drill, tap disintegrator, and Magnaglow equipment. If you are ready for a new start, send your resume to Rosalinda at [email protected]! Openings on all 3 shifts!

Perks & Benefits

Employment Type & Shifts

Job Responsibilities

• Performs a rework and salvage operation on the various axle housings, weldments, and components. Requires the use of gas metal arc welding and air arc equipment, a Hydro-Tel Mill, Sidney lathe, radial drill, expander, core drill, tap disintegrator, and Magnaglow equipment.
• Follows specified rework procedures established by Quality Control, Product Engineering, and Plant Engineering Departments
• Requires interpretation of detailed instructions and procedures, including process prints and blueprints, to determine dimensions, operating sequences, and required tooling and method.
• Changes perishable tooling and welding wire as required.
• Adjust machine settings and welding parameters as necessary to maintain quality.
• Uses a lift truck to transport parts and materials.
• Performs 100% the evaluation and disposition of material prior to rework operation, identification of reworked material according to specified procedures, and gauging to maintain rework quality. 

REQUIREMENTS:

• Detects and reports faulty operation of equipment, defective materials, and unusual conditions to the assigned supervisor.
• Maintains work area and equipment in a clean and orderly condition.
• Observes prescribed safety regulations, gauging frequencies, and other standards of operation and conduct.
• Performs duties of in-line welder, including but not limited to welding an internal cover weld on various weldments, inspection of all prior welds on the product, and repair welding in line as needed.
• Complete all required paperwork.
• Practice safety at all times.
• Performs other related duties as directed by assigned supervisor.
• Must be able to stand for an 8-12 hour shift.
• Must be able to push/pull with a force of up to 65 pounds.
• Must be able to lift up to 30 pounds, 50 pounds occasionally.
• MIG Welding experience is required. Associate must pass the weld test.

Associate Requirements